Does the IMX8MP support an I2C Channel on the 40-pin expansion header.  In the user interface diagram it depicts I2C available on the expansion header as well as the RP3 compatible header.&nbs...

@Olof Johansson Based on Ian's reply at https://www.ipi.wiki/community/forum/topic/99770/does-the-micro-fan-connector-on-the-module-work I'm planning to create a few adapters to connect to the modu...

I'm working on updating the firmware and hoping I can tweak the ACPI tables to allow more performance. For example I think it should be possible to enable the "Max Performance" setting, while at th...

Thanks! I'll try again with a less hacky solution (i.e. this time soldering wires).

Thanks @Master of SMARC  Sorry for the delay reply.  I was trying to get the board setup. Buying Smarc-1200 will I get access to neuro pilot SDK ? I dont see download link in the page yo...

On following the serial connection documention, I receive garbled output. The cable itself is fine. Is the instruction ok ?

Hi Rubio, Thanks. I tried this before and again it didnt work. Signal intensity picked up by Smarc 1200 is too low, so I moved the device closer to the WiFi AP and it did work.  Does the dev...

Hello, we've ordered a 80-core 2.6 GHz dev kit. While testing the frequency, I noticed 2.3 GHz. I looked at the various cpufreq settings for the CPPC driver, tried to enable "boost" (not supported...

I noticed the same, with the fan connected to FAN_0 it was not spinning and the module was getting warm. I moved it to FAN_1 and now it spins as expected.

A picture is worth a thousand words :-) ian

Hi Rebecca, I'm running my fans from the Fan header on the COM-HPC board to have system fan control.  I soldered a JST connector (https://www.amazon.com/dp/B09DYLY95R) to a male fan connector...

Hi Magesh, Sorry for the late reply. Please give a try with this commands listed below.   $ systemctl status NetworkManager.service $ rm -rf /etc/wpasupplicant.conf $ nmcli device wifi ...

Since FAN_0 isn't wired up, I decided to try buying some micro connectors, adapters and jumper wires and connect the SoC fan to the connector on the module.   Unfortunately it didn't work: t...

Hi Magesh, Sorry for the late reply due to a national holiday recently. I will push our team to give a feedback ASAP. Thank you for your patience. BR, Rubio

@Khoa Vu, Gratitude for the feedback.  

I got the Alphacool Eisbaer Pro Aurora 240 with the Eisblock XPX Pro LGA 4926 Ampere Mounting Bracket installed on my dev kit over the weekend.  Late last week I pulled off the stock cooler (i...

Hello again, As I am writing this post, the website is working correctly. Thanks to the staff for the quick responses. Best regards

Hello, I am browsing the documents of IMX8M PLUS and found that the contents on the website was replaced mostly with PX30.  The Unboxing section and sections below it are affected. https://...

Hi Rubio, Any update on this ?  

Does anybody know what the P_2V5_BMC_AUX is for? Lately mine has been showing only 0.02 volts (which means it's not getting power) which I'm pretty sure it did not do before. The board seems to be ...