Hello Magesh, the instruction is correct after confirming, I used Ubuntu 22.04.1 LTS (5.15.0-1028) did you follow the content as below link? https://www.ipi.wiki/pages/1200-docs?page=Ser...
Hello Magesh, the instruction is correct after confirming, I used Ubuntu 22.04.1 LTS (5.15.0-1028) did you follow the content as below link? https://www.ipi.wiki/pages/1200-docs?page=Ser...
Hi Tu Ken, I use linux minicom regards Magesh
Hello Magesh, may I ask what host users you use? Linux or Windows?
Hi Steve, see below pin definition for 40p RPI compatible connector: https://www.ipi.wiki/pages/imx8mp-docs?page=UserInterfaces.html Function MRAA Number MRAA number Function 3...
Hi! I have the i-pi smarc px30 board and i am trying to use the spi communication example code. I installed the Debian image (LEC-PX30-IPi-SMARC-Debian10-xfce-2v7-20210219) from the website, whic...
Does the IMX8MP support an I2C Channel on the 40-pin expansion header. In the user interface diagram it depicts I2C available on the expansion header as well as the RP3 compatible header.&nbs...
@Olof Johansson Based on Ian's reply at https://www.ipi.wiki/community/forum/topic/99770/does-the-micro-fan-connector-on-the-module-work I'm planning to create a few adapters to connect to the modu...
I'm working on updating the firmware and hoping I can tweak the ACPI tables to allow more performance. For example I think it should be possible to enable the "Max Performance" setting, while at th...
Thanks! I'll try again with a less hacky solution (i.e. this time soldering wires).
Thanks @Master of SMARC Sorry for the delay reply. I was trying to get the board setup. Buying Smarc-1200 will I get access to neuro pilot SDK ? I dont see download link in the page yo...
On following the serial connection documention, I receive garbled output. The cable itself is fine. Is the instruction ok ?
Hi Rubio, Thanks. I tried this before and again it didnt work. Signal intensity picked up by Smarc 1200 is too low, so I moved the device closer to the WiFi AP and it did work. Does the dev...
Hello, we've ordered a 80-core 2.6 GHz dev kit. While testing the frequency, I noticed 2.3 GHz. I looked at the various cpufreq settings for the CPPC driver, tried to enable "boost" (not supported...
I noticed the same, with the fan connected to FAN_0 it was not spinning and the module was getting warm. I moved it to FAN_1 and now it spins as expected.
A picture is worth a thousand words :-) ian
Hi Rebecca, I'm running my fans from the Fan header on the COM-HPC board to have system fan control. I soldered a JST connector (https://www.amazon.com/dp/B09DYLY95R) to a male fan connector...
Hi Magesh, Sorry for the late reply. Please give a try with this commands listed below. $ systemctl status NetworkManager.service $ rm -rf /etc/wpasupplicant.conf $ nmcli device wifi ...
Since FAN_0 isn't wired up, I decided to try buying some micro connectors, adapters and jumper wires and connect the SoC fan to the connector on the module. Unfortunately it didn't work: t...
Hi Magesh, Sorry for the late reply due to a national holiday recently. I will push our team to give a feedback ASAP. Thank you for your patience. BR, Rubio
@Khoa Vu, Gratitude for the feedback.