Hi Yu Kang,  OSM-IMX8MP is a product that is "hanging" for the moment, reason being the LPDDR4 status making the product economically no longer viable.  See it like this, in Jan 2025 4G...

We ran into a similar situation on COM-HPC platforms. In our case, the documentation mentioned UART console redirection, but the actual BIOS menu did not expose a direct “UART0 → UART1&r...

I'm confident that everyone will enjoy this post since it discusses this incredible item well enough för someone to understand. Moto X3m - Play Online for Free!  

I've had the exact same problem having flashed the latest EDKII. 7 minutes just to reach the point where you can interact with EFI. Other people in the forum indicated that this was due to the BMC...

Hello all, I am new to this forum, recently, I have been looking into the OSM IMX8MP module as a replacement of SMARC IMX8MP. There seems to be no official Yocto source code or even a subforum on ...

Dear Mango C., We have already contacted our AE team to support you, and the response has been sent to your email address. We will continue to follow up and communicate with you via email.

Dear @Nikolai Motorin, It’s not working out of the box because this board’s “COM/VGA serial” is built as a one-or-the-other mux, not an SOL wiring. For SOL to work, the BMC...

I am replacing parameters for this panel which is "supposedly" wired the same as a hydis-hv150ux2 which is supported, but replacing "data-mapping"="jeida" and data-width=18... The GPIOs are supoos...

Hi Floyd,  could you tell me what help you are searching? , LVDS panels are pretty simple to add into the device tree

Hi, we use UART0 as main console data output. But for the SOL feature we need to redirect it. According to COM-HPC-ALT User's guide it is possible to redirect console from UART0 to UART1 in BIOS. ...

Hi Hiro,  NI = Not installed, your assumption is correct

Does anyone have any experience with this panel? KAOHSIUNG OPTO-ELECTRONICS INC TX18D211VM0BAA18-bit VESA    

Hi there,@Adrian Walker ,1.) In the link you've provided there might be an error in the hardware specs/Module introduction: Processor Cores/Threads Cache TDP Graphics V3C48 8C/...

Today i receive my new Ampere Altra Developer Rugged from DHL carier. I can't boot system to run Ubuntu OS. I try to clear cmos it is not work. I try to press "ESC" to enter boot option & se...

Attached is the schematic of the Ethernet-related circuitry near the RJ45 connectors on the I-Pi SMARC carrier board.In the diagram, resistors R801, R802, R803, and R804 are marked as "NI", (I expe...

Thank you

You can check the hardware manual for SMARC LEC-IMX8MP — it usually lists the meaning and color codes of all status LEDs. If you don’t have it, try contacting ADLINK support; they can p...

But i cant able to find the target machine config which i need to mention in local.conf.please follow the flash manual below to find the target machine.   also flashing documentation pag...

Hi, I bought I-Pi SMARC 1200 for evaluation and followed the below github page to complete the yocto build.  https://github.com/ADLINK/meta-adlink-mtk/wiki/Building-Yocto-for-LEC%E2%80%9...