Hi Jiaheng, Sorry for USB4, 5 and USB6, 7 aren't supported on the COM-HPC-ALT(Ampere Altra) and only USB0, 1 and USB2, 3 on the rear are workable, cause the carrier are desinged as maxnimu...
Hi Jiaheng, Sorry for USB4, 5 and USB6, 7 aren't supported on the COM-HPC-ALT(Ampere Altra) and only USB0, 1 and USB2, 3 on the rear are workable, cause the carrier are desinged as maxnimu...
Hi Rebecca, As the current FAN_0 does not have a PWM signal due to an optional BOM on the module board, and only the module's BFAN_1 is activated in previous. The new BOM will activate bo...
Hi Ian, Rebecca, As the current FAN_0 does not have a PWM signal due to an optional BOM on the module board, and only the module's BFAN_1 is activated in previous. The new BOM will activa...
Hi Olof, Good to see you there, For JP2/3, both pins 1 and 2 should be connected. Before proceeding, please check if any jumpers are included in the packaging box or bag. You can...
Hi Jose, You could check if available to find the AVL as listed below link for Adlink AADK at first. https://www.ipi.wiki/pages/aadp-docs?page=MemorySupportAVL.html You can s...
@Rebecca Cran Hi Rebecca, To clarify, the DB40 should be considered an optional item rather than a mandatory one. As you may have noticed, there is an additional device labeled "Ded...
@Olof Johansson Hi Olof, There the SMBus has route bewteen PCIe and BMC, but for application as fecthing of temperatures information...etc, before command executing by BMC, ...