Hi,
I am very new to working with embedded devices, but I am trying to communicate with a device connected to the SPI1 header pins on the Amston Lake board. I am able to see in the kernel that SPI1 is there and I am able to see that there is a driver for the spidev but the there is no /dev/spidev or dev/bus/spidev. I've been going a bit in circles on how to be able to write to SPI1. I was also going to try to use the mraa repository in case I don't have to mess with these lower level settings but I'm getting errors while trying to install it. Help! Thanks!
Best,
Cassandra
It's frustrating when hardware setup becomes a roadblock. While using pre-built libraries like mraa can simplify things, addressing the missing /dev/spidev is key. Have you confirmed SPI1 is enabled in your device tree overlay or kernel configuration? Properly enabling SPI through those channels often resolves the device node issue.
Interesting article! For anyone planning a garden or green space, this grow a garden calculator is very handy for spacing, sunlight, and yield planning.
Informative resources here! You can also try the Peacock Free Trial to watch top shows and movies for free.
