Posts made by Henrik Vendelbo

• USB 2.0 OTG connector on i.MX 8 side

  Can you please clarify which USB port on the i.MX 8 chip the microUSB / USB 2.0 OTG connects to?

  posted in Hardware

  HV

  Henrik Vendelbo
  1/30/22, 7:37 PM
• micro USB serial connection

  I'm trying to connect to the micro USB serial connection. What drivers are needed? Which chipset is used?

  posted in Hardware

  HV

  Henrik Vendelbo
  1/28/22, 12:59 PM
• LVDS Connector Type

  What type of connector is used for the 30 pin LVDS socket/plug?

  posted in Hardware

  HV

  Henrik Vendelbo
  12/18/21, 5:30 PM
• Getting Started ...

  @Henrik Vendelbo Solution.  "Dip switches (bank of 4) are located near the Ethernet ports. Flip them to determine where the board should boot from" Putting this text before the obscure ...

  posted in Software

  HV

  Henrik Vendelbo
  12/16/21, 8:53 PM
• USB boot

  @Allumallu Susmitha What does this mean?But you need to use micro USB OTG cable to boot the board with Yocto/Ubuntu/android. Does it boot over the OTG cable?  

  posted in Hardware

  HV

  Henrik Vendelbo
  12/14/21, 7:02 PM
• Getting Started ...

  Broke out the board. Everthing looks very nice. Well done making U-Boot expose boot partition as MSD. I tried to follow the Getting Started documentation. It has holes... 1) Downloaded Yocto imag...

  posted in Software

  HV

  Henrik Vendelbo
  12/14/21, 6:55 PM