Can the OTG on this board be configured as a device side USB? Then by doing a "modprobe g_ether" can it be used as an ethernet connection through "usb0" interface?
Dear @Todd Bonack,
The PX30 supports OTG Mode, and by default the g_serial gadget is loaded, so you need to remove it to load ether. Here are the steps to follow to make PX30 work,
- Connect the OTG cable between the Target and Host.
- The serial gadget can be removed by running "rmmod g_serial".
- By using "modprobe g_ether", you can load ether modules.
- If you run "ifconfig", you will see that the USB0 interface has been created.
